The Frontier Sixshooter Community Message Board - I have CCI Small Pistol ... (nt)

I have CCI Small Pistol ... (nt) (reply)

JimT — Fri, 13 Oct 2023 12:52:07 +0000

I now have them ready to load ... (reply)

Creeker — Fri, 13 Oct 2023 12:23:05 +0000

Shot that load a bunch only with a Magma Machine Cast RNFP. Being all out of Bullseye I now use Promo as a replacement.Which primer are you using?

I now have them ready to load ... (reply)

JimT — Fri, 13 Oct 2023 03:32:02 +0000

sized, deprimed, neck expanded and primed.

I am planning on loading them with the 158 gr. SWC over 3 gr. of Bullseye.

I have them all sized and deprimed. (reply)

Creeker — Fri, 13 Oct 2023 01:24:26 +0000

I have a universal depriming die from RCBS I really like.

I have them all sized and deprimed. (reply)

JimT — Thu, 12 Oct 2023 17:11:24 +0000

Neck expanding is next. Then I will prime them all.

I finished shooting up the "mixed" .38 Spl. ammo yesterday. (reply)

Creeker — Thu, 12 Oct 2023 16:53:12 +0000

Need to shoot up some odd-ball stuff myself.

I finished shooting up the "mixed" .38 Spl. ammo yesterday.

JimT — Wed, 11 Oct 2023 20:10:13 +0000

Got all the brass cleaned and am ready to start reloading it all!

Some of the loads were light enough that I could see the bullet going to the target even though it was only 15 yards! One went in a slow rainbow arc, hit the cardboard backstop and bounced off. I walked to the target and picked up the bullet.

I pulled 3 of the bullets and found one loaded with 3 gr. of a dark flake powder I am sure is Bullseye. The other 2 had a fine grey powder and only 2.4 grains weight of it. Not sure what it was.

Anyway ..here is approximately 700 rounds ready to start the loading process.