The Frontier Sixshooter Community Message Board - Require? I wouldn't think.

Require? I wouldn't think. (reply)

cas — Mon, 25 Sep 2023 21:35:33 +0000

Don't think so, just optional? My 8 .32Rem sure don't require em.

Doug, good stuff, thanks! (reply)

Rob Leahy — Mon, 25 Sep 2023 16:26:23 +0000

Remington Model 81, 300 Savage. (reply)

A K Church — Mon, 25 Sep 2023 10:05:14 +0000

Mike thanks you for the info, and so do I.

Remington Model 81, 300 Savage. (reply)

Slow Hand — Sun, 24 Sep 2023 21:00:27 +0000

Not 100% familiar with the .300, but I know the .35’s use a special and very expensive stripper. I bought some 3d printed ones that in practice seem to work well. I haven’t had them out to the range yet, but loading it at home is basically the same as loading it at the range or in the field.

https://cogburnarsenal.com/product/remington-model-8-81-stripper-clips/

I never tried it but I would bet if you put a couple of bumps near the middle of each ‘skinny’ side to keep it from pushing down into the mag well, most any Mauser or USGI stripper would work.

Remington Model 81, 300 Savage.

A K Church — Sun, 24 Sep 2023 18:41:35 +0000

Host of today's shooting has a nice example of the type. Does it require a proprietary stripper clip to load the magazine, or is there something like an '03 stripper or such which works?