The Frontier Sixshooter Community Message Board - Lovely - A keeper for sure!

Lovely - A keeper for sure! (reply)

Mike P — Sat, 18 Mar 2023 18:52:19 +0000

I don't remember where it hit with the original sight. (reply)

JimT — Wed, 01 Mar 2023 02:35:30 +0000

I filed this one down until it was close at 20/25 yards. When I got it back from Gary it was hitting about 1" low. I did not take much off.

Did you shorten the front sight? (reply)

Hoot — Wed, 01 Mar 2023 01:58:43 +0000

It sure looks like it. How low was it shooting with the "standard" front?

A couple more pictures ... (reply)

JimT — Tue, 28 Feb 2023 14:26:08 +0000

Reeder's Deep Dish Crown

Super Single Six front sight

Gripframe and trigger guard I put on this gun 20-some years ago. The trigger guard I thinned to aid in my quick-draw. Or at least I thought it did.

Simply Rugged holster

All steel ejector rod housing from Bordchardt Rifle Company.

Nice looking little popper Jim. (reply)

Hoot — Tue, 28 Feb 2023 01:16:22 +0000

I need to do this as well. I have long neglected my little Rugers.

Took the Forgotten Single Six to the Range Today

JimT — Tue, 28 Feb 2023 00:49:12 +0000

Ran a couple hundred rounds through it. It was windy with 10 to 12 MPH gusts ... all shot at 20 yards.

Aguila .22 Long Rifle copper plated hollow point

CCI Mini Mag

Remington Golden Bullet hollow point

I had Gary Reeder cut the barrel to 4 5/8". I had him put a Ruger Super Single Six front sight on it and open up the rear notch. My old eyes can see it better than the small sight. I had an all-steel ejector rod housing I installed on it.