The Frontier Sixshooter Community Message Board - +1 On Starline better than Federal brass

+1 On Starline better than Federal brass (reply)

Cherokee — Sun, 05 Apr 2020 02:40:06 +0000

That is 30 Carbine performance in my Ruger 30C with GI ammo, high pressure for sure.

+1 On Starline better than Federal brass (reply)

E Sisk — Fri, 03 Apr 2020 02:36:02 +0000

I may try annealing my Federal brass, lots of split cases but they are all once fired brass. 100 gr. JSP which chronographed 1600 plus from my Single Seven. That's a lot of stress.

I think the .327 Fed is worth the expense. I have both the (reply)

Cherokee — Thu, 02 Apr 2020 14:03:32 +0000

I used some 571 in 357 Mag, 8.6 gr pushing 150 JHP. Was accurate for me.

I think the .327 Fed is worth the expense. I have both the (reply)

Hobie — Thu, 02 Apr 2020 13:23:04 +0000

Starline and Federal brass. Starline better. Have 2 Single-Sevens (blue Bisley and early Stainless) with 5½-inch barrels. I like the XTP bullet, too. I have not tried a lot of powders with it though. Was going to shoot it a lot last year but had the house re-build and now...

I've been studying on that 327 Federal for a while now, (reply)

Paul — Wed, 01 Apr 2020 21:05:27 +0000

https://www.starlinebrass.com/327-federal-mag is reportedly some of the best out there, but $0.26 each in a bag of 500, free shipping though.

Found a keg of Win 571 Powder... (HS7) Any useful data?

Mike P — Wed, 01 Apr 2020 20:33:52 +0000

Hi -

I have been cooped up with my lovely wife, and She Who Must be Obeyed directed some deep excavation. I survived, and on the upside I discovered a 5# can of Winchester 571 powder. It's marked $19.95 on the top.

I see it's the same as HS7. Is anyone using this stuff to push .45 Colt or ACP? or .38/.357. If so any pet load would be appreciated.

Also - I got a .327 Fed Mag. Brass is pricey. Anyone had a source?

Thanks & Stay Healthy!