The Frontier Sixshooter Community Message Board - Works for me - was actually easier to do than I feared

Works for me - was actually easier to do than I feared (reply)

stonewalrus — Sun, 17 Mar 2019 12:16:35 +0000

Apparently not that hard a steel.

How did you take it off? Did you remove the trigger to do it (reply)

MS — Sat, 16 Mar 2019 03:47:08 +0000

I just wedged it forward and used a narrow file across it to reshape the end.
Not very gunsmith like but it worked.

How did you take it off? Did you remove the trigger to do it (reply)

stonewalrus — Sun, 10 Mar 2019 23:31:50 +0000

Yes... (reply)

MS — Sun, 10 Mar 2019 15:57:51 +0000

A reshaping of the end of the safety blade fixed mine. I took a lot off it. Till the end was nearly flush with the trigger blade. The guns gone now, or I would take a pic.

Finger pinching LC9 - anybody else have this? (reply)

Cherokee — Sun, 10 Mar 2019 02:15:44 +0000

Like JT, happens with all those lever triggers to some extent. I have finally gotten my XDm's smoothed out to avoid it now.

One reason I bought a P365, my finger doesn't get (reply)

Hobie — Sat, 09 Mar 2019 05:00:21 +0000

pinched, the trigger doesn't have sharp edges... The 10-round magazine and relatively small size is a positive as well.

Finger pinching LC9 - anybody else have this? (reply)

SIXGUNNER — Sat, 09 Mar 2019 03:45:07 +0000

HAPPENS TO ME WITH ALL "SAFETY TRIGGERS". FOR ANY LONG SESSION I HAVE TO TAPE MY TRIGGER FINGER.

Finger pinching LC9 - anybody else have this?

stonewalrus — Sat, 09 Mar 2019 02:58:19 +0000

I have noticed if I fire more than a few rounds I end up with a sore trigger finger. I have googled and I am not the only one. I think it must be between the trigger and trigger guard. Didn’t see anybody having a solution. Anybody else having this problem? It has one of those trigger within a trigger “safeties” but I see no sharp or rough edges. Doesn’t seem to do it when dry firing it.