The Frontier Sixshooter Community Message Board - Looks good, big improvement over the factory

Looks good, big improvement over the factory (reply)

Creeker — Sat, 25 Aug 2018 01:21:35 +0000

I've considered that on a 44 of mine. This Ruger wasn't choked too bad. I fire lapped the barrel & my pin gauge passes with ease so thought simply re-cutting to 11 degrees would do the trick. Time will tell.

Looks good, big improvement over the factory (reply)

D. Sikes — Sat, 25 Aug 2018 01:13:15 +0000

Have you thought about doing a Taylor's throating as Jim Taylor's dad used to do on his SAA's?

Looks good, big improvement over the factory (reply)

Creeker — Sat, 25 Aug 2018 00:55:21 +0000

Not sure it will shoot any better as it does pretty good for a factory sixgun. It was leading on one side the forcing cone & a 1/2" or so into the rifling, same side. I'm hoping it will now stop. I'm out of bullets though & will have cast some before I'll know.

That ought to help. (reply)

Creeker — Sat, 25 Aug 2018 00:51:57 +0000

Fremin opened the ACP cylinder to .4535". The original 45 Colt cylinder came from the factory at .454".

Looks good, big improvement over the factory (reply)

Cherokee — Fri, 24 Aug 2018 19:13:51 +0000

cone. Now you have to tell us how it shoots.

That ought to help. (reply)

Miles — Fri, 24 Aug 2018 18:18:28 +0000

Do you know the chamber mouth diameters?

Forcing Cone

Creeker — Fri, 24 Aug 2018 16:08:32 +0000

Worked on mine yesterday.