The Frontier Sixshooter Community Message Board - Nice! As mentioned, grips may require attention

Nice! As mentioned, grips may require attention (reply)

BC — Sun, 16 Apr 2017 21:36:44 +0000

At a minimum, make sure they are located correctly, that the wood fit to metal isn't too proud, and that they are tightened down enough.

I was sorting brass last week... (reply)

Cherokee — Sat, 15 Apr 2017 23:18:48 +0000

Hay, ya had the brass, you needed the gun. Good show, get out there and enjoy the new Ruger.

There's a lot to be said... (reply)

mcassill — Sat, 15 Apr 2017 22:46:08 +0000

for Freedom Arms quality in calibers like that.

Watch the ERH, no recoil lug. Also, check the grips. (reply)

John K. — Sat, 15 Apr 2017 21:44:09 +0000

If the locating pin is mislocated and redrilled, the grips will shift and crack.

I was sorting brass last week...

Slow Hand — Sat, 15 Apr 2017 21:33:39 +0000

And I came across two pieces of .454 Casull brass. I don't own a .454, so I thought well, I could trim them back to .45 Colt length, but then I remembered that they use small rifle primers so that sounded like too much trouble. So, today I picked this up to put those two pieces of brass to good use!

Luckily it came with two boxes of Hornady ammo, a set of RCBS dies and 200 pieces of Starline brass!! Now to load up some ammo and find time to get it to the range.