The Frontier Sixshooter Community Message Board - Burl Birsdeye Mesquite Grips

Burl Birsdeye Mesquite Grips (reply)

Jeff Taylor — Mon, 27 Feb 2012 01:08:50 +0000

Wow, those are beautiful when finished and it looks like a reqarding project.

Beautiful! (reply)

brerarnold — Mon, 20 Feb 2012 02:21:56 +0000

Scott - email sent RE: french walnut grips...nm (reply)

SK — Mon, 20 Feb 2012 01:54:44 +0000

Relpy sent Matt

Scott - email sent RE: french walnut grips...nm (reply)

Matt/PA — Mon, 20 Feb 2012 01:21:20 +0000

As usual, they look great even unfinished.... (reply)

Cherokee — Sun, 19 Feb 2012 21:32:55 +0000

Burl Birsdeye Mesquite Grips

SK — Sun, 19 Feb 2012 19:34:38 +0000

Hi Folks, sure been a while. I really like the looks of the new page.
Just wanted to pass along something a little different. I had some clients ask for semi finished grips that thye could final fit themselves to avoid shipping their grip frame. I made some extra sets. The are about 90% finished. They are oversized about 1/8" to fit all XR3-red frames. The hardware is installed and they are contoured. All that need finished is to place on your frame and mark the locater pin hole, trace to your frame and remove the final material and final sand. These are only sanded to 150 grit and look at the figure, when sanded to 600 and finish is applied they will be stunning. If you have ever been interested in completitng your own grips and saving $'s, this is it. The hard work has been done.
You can have this set for $79 delivered. I have some others is French Walnut as well. All exhibition grade sets.
email if you have any questions or are interested in a different material
SK